SAFARI STORME MY14

ENGINE MANAGEMENT SYSTEM 188 4. Brake Pedal Switch It provides the information about the brake pedal status to EMS. The cruise can be cancelled when brake pedal is depressed. 5. Clutch Switch It provides the information about the clutch pedal status to EMS. The cruise can be cancelled when clutch pedal is depressed. 6. Vehicle Speed Input EMS receives the vehicle speed input from Wheel speed sensor in case of ABS/ESP vehicle. EMS internally converts the wheel speed to vehicle speed in kmph . NOTE In non – ABS vehicle, vehicle speed sensor gives vehicle speed input to EMS. 7. Cruise buttons on Steering wheel switches: A. RES( ACCELERATE/RESUME) ACCELERATE ( + ) The set speed can be increased using ‘+’ ( to increase ) button on Steering wheel. The set cruise speed increases by 3 km/h every time the ‘+’ button is pressed. Keeping the button pressed increases the speed continuously till the button is released. NOTE The set speed can also be increased by depressing the accelerator pedal till the desired speed is achieved and then pressing the SET button. RESUME ( RES ) Cruise speed can be resumed by pressing this button. Cruise speed can be resumed if cruise control is cancelled by depressing Clutch or Brake Pedal and pressing the CANCEL button on the steering wheel. To resume the previously set cruise speed, accelerate the vehicle to a speed above 35 Kmph and press RES button. NOTE Cruise speed can not be resumed if cruise control is cancelled by rotating cruise switch on combi switch. B.SET ( COAST/SET ) COAST ( - ) The set speed can be decreased using ‘-’ ( to decrease ) button on Steering wheel. The set cruise speed decrease by 3 km / h every time the “-‘ button is pressed. Keeping the button pressed decrease the speed continuously till the button is released. NOTE The set speed can also be decreased by tapping the clutch or brake pedal, (The cruise indicator will go off) and slowing down to desired speed and then pressing the SET button (The cruise indicator will come ON again). SET The desired speed can be set by pressing this button. First activate the Cruise control by rotating the cruise switch to ON position, which is located on right stalk of combi switch. Then attain the desired speed manually and press the SET button on Steering wheel to set the Cruise Speed. C. CANCEL Cruise control can be cancelled by pressing this button. NOTE • If the EMS is unable to maintain the cruise speed in an uphill gradient then it will come out of the Cruise mode. • In case of ABS / ESP Wheel Speed sensor failure the cruise control will be cancelled and the MIL Lamp will turn ON.