SAFARI

11 FUELSYSTEM 2.2LDICOR the sedimenter has to be drained. This sensor is fitted to the bottom part of the sedimenter where water separated from the fuel is stored. When the water reaches a defined level then the sensor output switches from high state to low state. The sensor is connected to the dash board to switch a lamp. Check if water in fuel sedimenter indicator lamp in instrument cluster is 'ON'. Drain the water from the sedimenter, by unscrewing the drain plug by 2 turns. Note Water ingress in Fuel System can result in CR system failure Water in fuel sedimenter indicator lamp (Fig. 8) This light comes ON when there is excess water in the Water sedimenter. In the event of this lamp glowing continuously, drain the water from the sedimenter. Procedure for DrainingWater fromSedimenter Stop the engine, and wait until pressure stabilizes. Unclip one of the hydraulic connections (either inlet or outlet) and the electric connector of the water sensor. Place a container underneath the sedimenter. Unscrew the water sensor about 2-3 turns. Wait until all the water has drained out of the water sedimenter. As soon as the flow is free of water, screw back the water sensor to the required torque. Clip the hydraulic connector and the electric connector to the water sensor. Use hand primer pump to refill the fuel line before restarting. Procedure for Sedimenter Removal (Fig.9): Clean the sedimentor, its connections,and the surrounding area. Disconnect the water senser electrical connector. Disconnect the fuel tank to sedimentor supply pipe (A) and plug the pipe and port with appropriate plug. Remove the hose (B) from sedimenter to fuel filter and plug the pipe and port with appropriate plug. Loosen and remove the M8 bolt with a suitable spanner of the fuel filter and sedimenter mounting bracket. Lift the Sedimenter. Fig. 8 Fig. 7 Fig. 9 B A