SAFARI

12 FUELSYSTEM2.2LDICOR Procedure for sedimenter Installation: Place the water sedimenter in the bracket with both protecting caps still in place. Avoid any spillage on the water sedimenter while hydraulic connectors are not fitted. Tighten the sedimenter on the bracket in the re- quired position. Identify inlet and outlet ports of the sedimenter with the help of printed arrows given on the top face of the sedimeter. Remove the protecting cap and clip the inlet hy- draulic connector. Do not force or bend the pipe. Remove the protecting cap and clip the outlet hy draulic connector. Do not force or bend the pipe. Screw the water sensor to the required torque Clip the electric connector to the water sensor. Check that there is no leakage after assembly. After starting the engine, check to make certain that the sedimenter warning light is off. Using hand primer refill the fuel lines before starting the vehicle. FUEL FILTER : This is located inside the engine compartment (Fig. 10 & 10A) Function / features 1. Particles filtration: to separate and store particles from the fuel and allow clean fuel into the CR System, sinceCRSystem is very sensitive to foreign particles in supply fuel. (Fig. 6) 2. Water separation: to separate and store water naturally found in the fuel. 3. Air management: tomanage the air naturally found in the fuel such that the CR system can handle it (due to a patented Bubble breaker tube). 4. Fuel de-waxing by hot fuel recirculation. Note The water sedimenter and fuel filter must be drained when dashboard indication appears. It is recommended to drain at every service interval. Ports of the fuel filter and sedimenter to be plugged with caps once the pipes are removed. Removal of Fuel Filter : - Clean the filter and surrounding area using a clean brush. Disconnect the fuel pump to filter return line from the filter and plug the pipe with the appropriate plug. Fig. 10A Water drain plug Fig. 10