514 / 801
BODY
70
INITIALIZING COMMAND PROCEDURE:
To initialize the sliding sunroof, use the following
procedure.
1. Turn ON the ignition
2.
Sunroof to be in close position
. Press the
‘sunroof close switch’ and
hold it for 9 to 10
seconds
. During this process, Sunroof goes to
TILT position and makes clicking sound and
stops at Tilt position.
3. Close Sunroof by again pressing close switch.
4. The Initializing command is complete, check if
the Express open/close features are working.
NOTE:
If the initializing procedure is not completely
performed, then it has to be run again from
step 2.
Self-learning the sunroof must be done after
completion of Initializing the sunroof.
Self-Learning is being done to learn the frictional
forces of the system and to set the parameters in
ECU as per current condition of the system
SELF LEARNING COMMAND PROCEDURE:
1. Sliding sunroof shall be in open position within
4mm to 200mm from the front edge of cutout.
2. Close the sunroof fully by pressing ‘sunroof
close switch’ and keep the switch pressed
continuously. Do not release the switch and
wait for following actions to perform.
3. Once Sliding sunroof reaches to closed
position, will start its cycle after 8 sec, delay.
Sunroof start to self-learning, run from close -
tilt – close – partial open – close (10 seconds).
Overall, 16 to18 seconds required to complete
self-learning.
4. The Self learning command is complete.
NOTE:
Incase Sunroof Close switch is released in the
middle of procedure, repeat from step 1.