Background Image
Table of Contents Table of Contents
Previous Page  20 / 1006 Next Page
Information
Show Menu
Previous Page 20 / 1006 Next Page
Page Background

1.2L REVOTRON ENGINE

9

3. Poor Engine Performance

Condition

Possible Cause

Remedy

Maximum RPM -low

Insufficient battery voltage/charge -

test battery and charging system.

Clean

and

tighten

battery

connections

Jump start engine.

Battery or charging system

component faulty. Replace as

necessary.

Obstructed air filter or air inlet

Clean or replace air filter or inlet.

Improper grade or contaminated

fuel

Rush fuel system with fresh, clean,

fuel of the correct type. Replace

fuel filter.

Faulty spark plugs, wires, or ignition

coil

Check ignition system components

for proper operation. Replace as

necessary.

Malfunctioning engine management

system component

Perform engine management

system

diagnostic

test

as

described in this section of the

manual.

Fuel filter if clogged.

Replace the fuel filter.

fuel lines are pinched or clogged

Correct the routine to avoid pinch,

or allow shop air to clear the clog in

the fuel lines.

Improper Electrical supply at pump

connector

If electrical supply is in proper

check electrical system.

In adequate fuel pump pressure

IF fuel pump does not built

pressure then replace.

Incorrect crank angle signal

Check sensor gap and adjust to

1.0 ± 0.4mm

Clogged or faulty fuel injector(s)

Check fuel injector operation.

Replace as necessary.

Improper firing order

Check ignition system and fuel

injector connections. Rectify as

necessary.

Exhaust system / Catcon damaged

Check and take corrective action.

Poor acceleration or low

power

Insufficient battery voltage/charge -

test battery and charging system

Clean

and

tighten

battery

connections

Battery or charging system

component faulty. Replace as

necessary.

Obstructed air filter or air inlet

Clean or replace air filter or inlet.

Disconnected or leaking vacuum

line or vacuum leak at inlet manifold

Inspect all vacuum lines and inlet

manifold. Repair or replace as

necessary.