HEXA

SUPPLEMENTARY RESTRAINT SYSTEM (SRS)

Inspection, repair and replacement required in SRS system after accident

The complete airbag system consists of fol-

lowing components. Those cannot be ser-

viced/repaired, hence should be replaced in

case of any damage/deployment

irrespective

of ‘if found ok’

a) Driver airbag

b) Passenger airbag

c) Seat belt assembly

d) Front impact sensors

e) Side impact sensors

f) Side airbags

g) Side Curtain airbags (Inflatable Curtains)

h) Wiring harnesses

i) SRS ECU

j) Clock spring

k) Passenger airbag deactivation switch

If Frontal Airbags, seat belt pretensioners are

deployed during collision, following compo-

nents must be replaced

irrespective of ‘if

found ok’

a) Driver airbag

b) Passenger airbag

c) Front Seat belt assembly RH & LH

d) Front impact sensors -LH & RH

e) Cockpit (with PAB provision & wiring har-

ness)

f) Wiring harness

g) SRS ECU

h) Clock spring

If Side Airbags, curtain airbags are deployed

during collision, following components must

be replaced

irrespective of ‘if found ok’

a) Deployed Side airbag(s)

b) Deployed Curtain Airbag(s)

c) Front Seat belt assembly for the side(s) that

deployed

d) Side impact sensor(s) for the side that de-

ployed

e) SRS ECU

f) Wiring harness

In case of Curtain Airbag deployment follow-

ing components also needs to be replaced

ir-

respective of ‘if found ok’

a) Roof trim

b) A –pillar trim

c) B – pillar upper and lower trims

d) C – pillar trim

e) Rear grab handle

f) Front grab handle

g) All related trim clips

h) Sun visor

5. After any type of vehicle accident, thoroughly

inspect all the airbag system components for any

damage or deformation. Replace components as

required. Thorough inspection of their mounting

locations is also strongly recommended after any

accident.

6. If any damage or deformation is observed on any

airbag system components, these components

MUST be replaced

even if they are not de-

ployed/ fired in the accident and are showing

healthy status when checked.

7. Special attention should be paid to mounting sur-

faces and mounting brackets mainly for SRS

ECU, Front impact sensors and Side impact sen-

sors as they are extremely critical for perfor-

mance of the system. If these cannot be repaired

to their original condition, the original panel(s)

MUST be replaced

8. In case of damage to SRS wiring harness/wires,

they must not be repaired but replaced.

9. If steering wheel and steering column are de-

formed or if the steering column is collapsed in an

accident replace these components.

10.The accident Vehicle should be inspected to

identify component deformation or structural de-

formations, damages for repair or replacement.

e.g. Vehicle front, side, rear structure, seats, un-

derbody components etc.

11.Check for DTC’s using diagnostic tool and trou-

bleshoot to clear all the DTC’s detected.

WARNING

‘

If the SRS warning indicator in the instrument cluster

illuminates continuously, it means there is a malfunc-

tion in the system, vehicle needs to be diagnosed so

take the vehicle to nearest TATA Authorized Service

Center’.