934 / 1236
ELECTRICAL
156
DISARM STATE:
If vehicle is in arm or pre arm state (i.e.
vehicle state is lock) and remote unlock button is
pressed, vehicle goes in disarm state. During 20
sec. pre arm state, if ignition or crank is made on
vehicle returns to the disarm state. Vehicle goes in
disarm state if vehicle is in unlock state due to:
Reverse cycling
Inertia activation
Actuator faculty condition
NOTE:
Theft can not be detected in disarm and
prearm state.
PRE ARM STATE:
On remote lock button press, the vehicle
changes the state from disarm to 20 sec pre arm
when vehicle get auto relock after 45 sec, vehicle
will enter into pre-arm state, if it was unlocked from
pre arm state (
provided auto relock feature is
enable
).
ARMED STATE:
The armed state is entered upon
completion of the pre-armed state. Any alarm
inputs that remained undetected after the 20s pre-
arm are ignored (
not scanned
).
If any previously open system input
becomes closed after the 20s pre-arm delay and
during the armed state, it will be subsequently be
scanned as a valid alarm system input.
Vehicle
alarm system starts hooting for 30 sec and flashing
for 5 min due to any of the following conditions: -
Turning the Ignition to RUN or START
(
CRANK
) with key after 20 s pre-arm phase.
Any door including tailgate and bonnet is
“seen” as open (
ajar switch changes state
)
The radio sense line becomes open circuit
If during an alarm event, the power is
disconnected to the system/ vehicle, upon
reconnection, the system will continue in the state
it was before the disconnection. A power
disconnection and reconnection must not affect the
alarm system.
NOTE:
A maximum of 10 alarm sequences (theft
conditions) can be detected in the same arm state.
Once the vehicle goes in disarm state, the counter
resets to zero.
FORCE PANIC:
When both remote lock and remote unlock
buttons are pressed simultaneously, forced panic
state gets activated. Hooting and flashing will start
continuously. The hooting and flashing can be
stopped by either lock or unlock button press. It will
return to disarm state if force panic is activated
from disarm state otherwise it will go in arm state.
NOTE:
During force panic state, if lock or unlock button on
remote is pressed, it will stop force panic indication
and no actuator or arm state operation takes place.