1372 / 1428
ELECTRICAL
33
2.8 DIAGNOSTIC TROUBLE CODES – INSTRUMENT CLUSTER
Sr
No DTC Code
DTC
Descriptio
n
Minimum Time for
Fault Setting /
Tester Visibility,
Assuming Fault
was created while
Ignition was OFF
Impact on customer Probable cause
Investigation/Rectificati
on/Repair action
1
U0028 13
Vehicle
Communic
ation Bus
A - circuit
open
600ms
EPAS lamp ON, CE
Lamp ON, MIL Lamp
ON. Default steering
assistance, EMS will
go into default mode.
Gear cannot be
changed. TCM will go
into default mode.
TCM Lamp ON
1. Open circuit failure of
CAN High line at IPC wiring
harness connector.
2. Open circuit failure of
CAN low line at IPC wiring
harness connector.
3. Open CAN High or Low
line terminal back out at IPC
wiring harness connector.
1. Check resistance
between CAN H and
CAN L line at OBD
connector.
2. If measured resistance
is in the range 11 to
130ohm, then either IPC
or ECM CAN lines are
not connected properly in
vehicle.
3. Repair the wiring
harness.