296 / 896
ENGINE 273 MPFI
282
P Code Description as per ISO/SAE
Fault cause MIL /
Blink Diag Detection / Customer Effect
Probable Trouble area
Check Code Tool
for
BS-III-IV
6) Check for damage of pins at both sensor connector
and ECU connector.
7) Damaged Flywheel Gears/TARGETWHEEL.
8) MISALIGNMENT/ IncreasedAirgap OFTHE SENSOR.
9) Faulty CKP Sensor.
10) Faulty ECU
P0351
Ignition Coil Primary/Secondary Circuit
Short Circuit
ON 31 YES 1. Engine shuts off and can be only started after Ignition switch 1) Loose /Damaged connector.
to Battery
resetting or coil has cooled down.
2) IGN Coil supply line short to Battery/Ground
2.Misfire may happen.
3) IGN Coil Control line Short to Battery/ Ground.
4) Check the continuity from Ignition Coil connector pins
to the ECU pins ( ECU pin 55-Ignition Coil pin 2).12 volts
should come at ignition ON.
5) Check for back out of pins at both Ignition Coil
connector and ECU connector.
6) Faulty Ignition Coil/ HT Leads/ Spark Plugs.
7) Faulty ECU
P0443
Evaporative Emission System Purge Control
Signal Error
ON 18 YES 1. No effect on starting or drivability.
1) Loose/ Damaged Connections or Intermittent fault.
Valve Circuit Signal Error
2)Actuator supply line Short circuit to Battery/ Ground.
3)Actuator control line Short circuit to Battery/ Ground.
P0458
Evaporative Emission System Purge Control
Short Circuit
ON 18 YES 1. Starting may get affected.
4) Check the continuity from Canister Purge connector
ValveCircuitLow
to Ground
2. Idle RPM is not stable.
pin 1 to the ECU pin 15.
5) Check for back out of pins at both Sensor connector
P0459
Evaporative Emission System Purge Control
Short Circuit
ON 18 YES 1. No effect on starting or drivability.
and ECU connector.
ValveCircuitHigh
to Battery
6) Canister purge valve stuck/closed.
7) Faulty EPCV.
8) Faulty ECU
P0480
Radiator Fan Relay Control Circuit fault
SignalError
ON 38 YES 1. Fan is not running.
1) Loose/ Damaged Connections.
2. Engine heat up & seize and may cause damage to components. 2) Relay supply line Short circuit to Battery/ Ground.
3) Relay Control line Short circuit to Battery/ Ground.
P0482
Condensor Fan Relay Control Circuit fault
Signal Error
OFF 51 YES 1.A/C Fan is not running.
4) Check the continuity from Radiator Fan Relay
connector pin to the ECU pin 4.
5) Check for back out of pins at ECU connector.
6) Faulty/Damaged Relay
P0501
VehicleSpeedSensorRange/Performance
SignalError
ON 24 YES 1. Vehicle won’t go over 3000 RPM.
1) Loose/ Damaged Connections.
2. Limp Home mode is active.
2) Sensor supply line Short circuit to Battery/ Ground.
3. Exhaust may get heated.
3) Sensor Signal line Short circuit to Battery/ Ground.
4) Check the continuity from instrument cluster vehicle
speed pin to the ECU pin no 45.
5) Check for back out of pins at ECU connector.
6) INSTRUMENTCLUSTER
7) Faulty VSS.
8) Faulty ECU.