1.2L REVOTRON ENGINE 101 FITMENT For fitment follow the reverse order of removal. Tighten fasteners to the recommended torque. Thermostat cover mounting: M6 Bolt– (1 Kg-m) Checking procedure of thermostat: 1. Remove thermostat element from thermostat housing. 2. Mount thermostat element in a suitable fixture and place the fixture in a vessel filled with water. 3. Fix dial gauge with its spindle on valve surface with a pretension of 0.5mm 4. Heat the vessel and measure the water temperature with proper thermometer. 5. Note down the temperature when dial gauge needles starts moving indicating valve opening. 6. Note down the water temperature for needle movement (for valve fully open position). 7. The opening temperature and fully open temperature as measured should be as per the mentioned specifications. If they do not meet the specifications, replace the thermostat element. I. COMPRESSOR AND ALTERNATOR BELT REMOVAL. The belt used in this vehicle is multi ribbed belt. This belt is pre-tensioned over Air conditioner compressor and crank shaft pulley and therefore do not require the tensioner as this is capable of efficient power transmission. CAUTION The belt is not interchangeable and should not be interchanged with normal multiribbed belts. 1. Remove front RH mud liner. (Refer Body section for removal procedure). 2. Rotate the tensioner point by using ring spanner opposite to belt tension to remove the belt
RkJQdWJsaXNoZXIy MTIwNTUz