HV ELECTRICAL SYSTEM 25 NOTE: If you remove the charging gun from the vehicle and if you wish to reinsert the gun to recharge the vehicle, please wait for at least 10 seconds before charging gun is plugged again. In emergency charging shutdown conditions, Gun won’t be unlocked. Contact authorised TATA Service Centre. Action to be taken when charging stops abruptly Check the reason for interruption of charging. (Refer ‘Troubleshooting guide for Normal Charging’ table). Switch off the supply. Remove the charging gun from the charging inlet. Wait for 5 minutes. Restart the charging. (Refer charging procedure). Cleaning of Charging Inlet: Covering the charging gun and charging in-let by dust cap will ensure protection from water and dust. Precautions to be taken while cleaning the charging inlet: Keep the vehicle lid always closed. When the lid is open ensure that dust caps are in closed position. During normal charging, make sure that DC charging cap is closed. In case of dust/mud accumulation in charging port, it can be cleaned by blowing air to clean the CCS2. Allow the water to drain completely through drain holes. Allow the charging port to dry completely. NOTE: In case of any water ingress in the socket cavity, allow it to drain through the drain hole. Make sure the charging port is dry.
RkJQdWJsaXNoZXIy MTIwNTUz