RH SPRING ORIENTATION 3. Spring & Spring seat assembly to be fitted on to the RTB bigger dia hole. 4. Raise the torsion beam using hydraulic jack so that the coil spring gets compressed and shock absorber sits exactly over torsion beam properly. 5. Refit the Rear Shock Absorber Bottom Fastener & apply torque. (As per torque table). 6. Refit the rear wheels. 7. Remove the Car from 2 Post Lift. M. TORSION BEAM REMOVAL REMOVAL 1. Position the vehicle in the two post lift. 2. Remove the wheel cap and loosen wheel nuts. 3. Lift the vehicle using two post lift. 4. Remove the wheel. 5. Remove the brake drum / Disc brake if applicable. 6. Slacken off the hand brake cable (If applicable). 7. Detach the hand brake cable from the lever on the trailing shoe by moving the lever towards the center of the brake and removing the cable nipple from its location in the end of the lever (If applicable). 8. Remove the hand brake cable holder lock pin from the back plate (If applicable). SUSPENSION (MR) 42
RkJQdWJsaXNoZXIy MTIwNTUz