2. Fit the circlip. 3. Place the knuckle assembly over the hub. Using drift part No. 2576 5890 4401 press the knuckle assembly on the hub. E. SUBFRAME ASSEMBLY REMOVAL & ASSEMBLY 1. Remove the front wheel. 2. Remove the steering tie rod ball joint mounting Nut. 3. Remove tie rod ball joint using puller part No. 2702 5890 4602. 4. Disconnect the steering (Refer steering section). 5. Disconnect Stab Link. NOTE Ensure mounting surfaces of bearing on steering knuckle and hub should be free from dust, rust, foreign particles, oil and grease etc prior to assembly. Handle bearing with clean, dry hands and never use hand glove while assembling. Never hammer the bearing while assembly and removal. No damages to bearing is permitted. During pressing the bearing into knuckle, ensure marking to be at inboard Side of vehicle. SUSPENSION (MR) 33
RkJQdWJsaXNoZXIy MTIwNTUz