Using clamp part No. 2779 5890 3303 puller 18. part No. 2654 5890 3508 and rest part No. 2702 5890 2612 remove inner race of bearing from the hub. ASSEMBLY 1. Follow the above steps in reverse order in appropriate sequence for its assembly. 2. Tighten drive shaft nut 24.5 ± 1.5 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. D. OVERHAULING OF KNUCKLE AND WHEEL HUB SUB ASSEMBLY Clean all the parts thoroughly and replace damage / worn out parts. With the help of drift part No. 2779 5890 3301 1. and 2640 5890 3511 fit bearing in the knuckle. PRECAUTION: Use a new hub bearing and new circlip no oiling of bearing housing in knuckle carrier and hub, it should be free from dust and oil before pressing bearing into knuckle hub. Old bearing & circlip even if serviceable cannot be reused. NOTE Before Installation refer Sub assembly of knuckle / Hub & Bearing installation procedure. NOTE While assembling front Hub bearing magnetic tape should be at inboard side. SUSPENSION (MR) 32
RkJQdWJsaXNoZXIy MTIwNTUz