FIXING WINDSHIELD GLASS • Insert Windshield glass Locators in BIW Holes for positioning the glass. After the above preparation mount the glass on the body flange from outside this operation should be done within 15 minutes of the application of sealant on the glass. After mounting the glass, the same has to be pulled towards inside of body with the help of vacuum cups. Slightly tap the glass all around with hand for proper seating of glass mould. Wipe off the excessive spill off of sealant with clean dry rags. Do not use iso-propanol. Keep the vacuum cups pulled for 10 to 12 minutes as mentioned above. Do not drive the car for 2 hours. FIXING TAIL GATE GLASS • Repeat the above procedure for Tail gate glass. For Tail gate glass, after fixing, use Tensioner belt for holding the glass with flange. Insert rubber stoppers at bottom edge to push the glass with rubber seal as far as possible. SR NO PREPARATION ON GLASS (WINDSHIELD AND TAIL GATE GLASS) PREPARATION ON BODY SHELL 1 Clean the glass with cleaner Betaseal 43518. Allow it to dry completely. Assemble the rubber mould to the glass. Clean the Body shell flange area conforming to glass with Cleaner Betaseal 43518. Allow it to dry completely. 2 Apply a thin and even (Approx. 0.5 mm thick wet layer) of Primer Betaseal 43520A on Allow it to dry for minimum 2 minutes. Apply a thin and even coat (Approx. 0.5 mm thick wet layer) of Primer Betaseal glass.43533AT on painted surface. Allow it to dry for minimum 2 minutes. 3 Fill up the mould groove with Sealant Betaseal 58702 with the applicator gun. (This sealant at later stage spreads on glass and mating shell flange area, when glass is fixed.) BODY 61
RkJQdWJsaXNoZXIy MTIwNTUz