SUSPENSION_LR 33 4. Assemble the steering rack assembly to Subframe. 5. Raise the cross member to the body. 6. Fix the Subframe to the vehicle by tightening the four bolts and one screw. 7. Assemble crank reinforcement bracket. 8. Fix Battery connection wiring harness on reinforcement bracket. 9. Fix underbody battery connection guard. 10.Connect the EPAS for the rack assembly. 11.Fit the tie rod ball joint of steering rack to the knuckle. 12.Fix the lower arm to the knuckle. 13.Fix the 'C' mount and stab link. 14.Install exhaust Front Pipe Assy. 15.Assemble the underbody cover. E. REAR SHOCK ABSORBER AND COIL SPRINGS I. REMOVAL OF REAR SHOCK ABSORBER AND COIL SPRINGS 1) Lift the car using two-post lift. 2) Remove Rear Wheel. 3) Position the hydraulic jack below the coil spring pad of torsion beam in such a way that it slightly compresses the spring. 4) Loosen rear Shock Absorber bottom fastener 5) Similarly carry out the above steps for the other side. 6) Remove both the shock absorber fasteners holding the torsion beam using hydraulic jack at any one side. 7) Now slowly release and hold the hydraulic jack pressure so that both the coil springs along with top rubber can be pulled out. CAUTION: Do not lower the torsion beam below certain level as the brake hoses will be damaged.
RkJQdWJsaXNoZXIy MTIwNTUz