SUSPENSION_MR 30 16.Using clamp part No. 2779 5890 3303 puller part No. 2654 5890 3508 and rest part No. 2702 5890 2612 remove inner race of bearing from the hub 17. Remove circlip from knuckle. 18. Pull out knuckle bearing using puller part No. 2779 5890 3302 INSTALLATION: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. NOTE: High / Low point matching on Hub and Disc Observe the condition of disc surface. If the disc surface is smooth ensure that punch mark (Low Point) on disc and hub (High Point) are aligned and assembled. If the disc surface is uneven showing rough marks, grooves - machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face. Punch mark around bolt hole where run out on dia 220 is at low point. Align low point on disc and high point on hub while assembly. Assemble with countersunk screws. 2. Tighten drive shaft nut 17.5 ± 2 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing and new circlip, oil the bearing housing in knuckle carrier and hub itself. Old bearing, even if serviceable cannot be reused.
RkJQdWJsaXNoZXIy MTIwNTUz