9. Remove the lower arm assembly 9.4.1. REMOVAL AND INSTALLATION OF ANTI ROLL BAR 1. Position the vehicle on two post lift. 2. Remove lower nyloc nut of ball joint securing Stab link to the anti roll bar. 3. Do markings at the area shown by arrows, before removing anti roll bar mounting clamp bolts so that anti roll bar can be easily centralized while installation. 4. Remove anti roll bar mounting clamp screw (06) and take out anti roll bar along with washer (7). Installation 1. Mount anti roll bar but do not tighten the bolts. Align paint mark with bush face to centralize anti roll bar. 2. Ensure ball joint face (a) of anti roll bar link is parallel to mounting face of anti roll bar (b). 3. By holding the hex on the shank of the ball joint with a spanner, keep on tightening the lower nyloc nut till the threads protrude about 6 to 7 mm out-side the nut. 4. Tighten anti roll bar mounting clamp bolts. 9.4.2. REMOVAL OF LOWER ARM BALL JOINT 1. Removal process a) Support (part no. 5427 5890 32 01) to be used for ball joint removal. b) Circlip to be removed before dismantle the ball joint assembly from control arm. c) Ball joint to be removed on hydraulic press. NOTE Fit ARB on Sub frame using preloading • conditions. SUSPENSION_PETROL 34
RkJQdWJsaXNoZXIy MTIwNTUz