Remove circlip from knuckle. 18. Pull out knuckle bearing using puller part No. 19. 2779 5890 3302 INSTALLATION: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. 2. Tighten drive shaft nut 24.5 ± 1.5 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing and new circlip. Old bearing, even if serviceable cannot be reused. NOTE High / Low point matching on Hub and Disc • Observe the condition of disc surface. If the disc surface is smooth ensure that punch mark (Low Point) on disc and hub (High Point) are aligned and assembled. the disc surface is uneven showing rough • marks, grooves - machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face. mark around bolt hole where run out on dia • 220 is at low point. low point on disc and high point on hub while • assembly. Assemble with countersunk screws. SUSPENSION_PETROL 32
RkJQdWJsaXNoZXIy MTIwNTUz