Remove Oil Feeder Lay shaft. 23. Remove cylindrical roller bearing of Input shaft 24. from front housing with the help of puller 5438 5890 2618. PROCEDURE FOR REMOVAL OF INPUT SHAFT BEARING Position the transaxle RH side case, facing the • bearing in upward direction. Take the bearing puller (5438 5809 2618) and • place the outer hub of puller on the machined surface of transaxle casing, surrounding of the input shaft bearing. Rotate the pulling nut 30 mm anticlockwise and • allow anchoring body shaft of puller to get inserted inside the bearing. Once the anchoring body is inserted fully, hold • the locking stud on the top using open end spanner 8 mm and turn the locking nut on the top slowly using open end spanner 17 mm, few turns till it gets resistance to rotate. It allows flaring the anchoring body and gets • lock with bearing rollers. TRANSAXLE (TA6300) 41
RkJQdWJsaXNoZXIy MTIwNTUz