It allows flaring the anchoring body and gets • lock with bearing rollers. Once the anchoring body is locked with bearing • hold the anchoring body shaft at the top using the open end spanner 18 mm. Use the open-end spanner 30 mm and turn the • pulling nut clockwise, do not allow anchoring shaft to turn along with pulling nut. It will start to pull the bearing out from the • casing. Turn the pulling nut (30 mm) till the bearing • comes out completely from the casing. Once the bearing comes out, unlock the • anchoring shaft by turning the locking nut anticlockwise on the top and slowly tap on the locking stud down to unlock the bearing from anchoring body and to remove bearing from the tool. CAUTION stop once the shaft is locked, excess rotation • of locking nut may cause damage to puller of bearing. TRANSAXLE (TA6300) 40
RkJQdWJsaXNoZXIy MTIwNTUz