Remove both front tyres. 31. Remove the left and right drive shafts from the 32. vehicle. (For removal procedures refer Transaxle section). Use suitable belt/chain to fix a zip crane to the 33. engine lifting hooks located at front and rear of the engine. Raise the crane slightly up until very light 34. pressure is applied to the engine. Loosen and remove the 2 mounting nuts and 35. one bolt on engine ‘B’ mount assembly. Remove the “A” mount assembly. 36. Remove the “C” mount assembly and the 37. rubber stopper. Now move the two post lift upwards and place 38. the support stand, under the engine. (Use a suitable wooden block or other support for additional height as necessary.) Now slightly lower the lift until engine and 39. transaxle assembly is securely placed / fix on the support stand. Disconnect the lifting crane from the engine. 40. SPECIAL TOOL Engine Support stand 5438 5890 2402 • Diesel Engine Ph-2 (CAFÉ) 106
RkJQdWJsaXNoZXIy MTIwNTUz