ASSEMBLY OF CYLINDER HEAD IV. 1. Place the cylinder head on the table. 2. Mount the cylinder head gasket over the block with locating dowel. 3. Assemble the cylinder head on the block. 4. Tighten the fasteners as per given sequence. 5. Assemble the lower ITG Bearing Cap with locating dowels. Ensure the NRV (Non return valve) in place inside lower ITG. 6. Place the camshafts to their respective location in such way that the cam lobes of first cylinder are opposite to each other as shown. 7. Assemble the ITG Bearing Cap Upper with the mounting fasteners. NOTE Match the gasket profile to Cylinder block • surface as shown in figure. NOTE Cam lobes should not be pressing any • valves. Petrol Engine Ph-2 (CAFÉ) 150
RkJQdWJsaXNoZXIy MTIwNTUz