3. Clean the dust or any liquid spillage on the mat. FITMENT Follow the reverse process for fitment of the mat after cleaning. E. DASHBOARD SKIN (TOP PANEL ASSEMBLY INCLUDING DUCT ASSEMBLY, PAB CHUTE, AIR VENT ASSEMBLY ETC.) REMOVAL 1. Remove steering wheel with Driver air bag (if applicable) (For procedure refer steering wheel removal process in steering section.) 2. Remove End Cap RH. Pull out Driver lower panel. 3. Remove nacelle Assembly. Nacelle Upper assembly detached from Nacelle Lower & Cluster Cover (Gap Hider which is a part of Nacelle Upper is attached to Cluster Cover by rib locks) (For removal refer steering column removal process in steering section) 4. Remove Nacelle Lower (by removing three screws with steering column) 5. Remove combination switch assembly and ignition switch assembly (For procedure refers combination switch and ignition switch removal process in Electrical section) NOTE Push the mat properly at Locking and Front Right Corner to ensure perfect fitment. BODY 12
RkJQdWJsaXNoZXIy MTIwNTUz