3. Fit and rotate the top rubber with the coil spring. LH Spring Orientation RH Spring Orientation 4. Position the spring bottom rubber pad is to fixed to twist beam in two holes. Spring to be oriented such that end rest and against the stopper of bottom rubber pad. 5. Raise the torsion beam using hydraulic jack so that the coil spring gets compressed and shock absorber sits exactly over torsion beam properly. 6. Refit and Torque Rear Shock Absorber Bottom Fastener. (as per specified). 7. Refit the rear wheels. 8. Remove the Car from 2 Post Lift. F. REMOVAL OF REAR GEN 3 BEARING 1. Position the vehicle in the two post lift. 2. Remove the wheel cap and loosen wheel nuts. 3. Lift the vehicle using two post lift. 4. Remove the wheel. NOTE While fitment of damper the bottom bush to • be tighten in Preloading condition. Jacking on the beam not to be done to avoid failure. SUSPENSION_DIESEL 36
RkJQdWJsaXNoZXIy MTIwNTUz