BODY 12 C. SUN ROOF / TILT AND SLIDE ROOF 1. Precautions for Sun Roof i) Water Leakage Test Perform water leakage test after installing Glass Panel Assy. Adjust Glass Panel Assy mount position again in case of water leakage. (Replace Glass Panel Assy if sun roof weather-strip included in Glass panel Assy is defective.) Do not apply excessive water pressure during water leakage test. ii) Installation and Replacement Do not apply large impact to sun roof motor, such as by dropping it. Do not pinch any object during initialization of sun roof motor, sun roof cable. iii) Anti-Pinching Function Check Do not use any part of your body such as hand or arm to check this function. Pay enough attention to avoid body from being pinched during check. Anti-pinching function works only in auto tilt down and sliding function in closing direction. Do not check in manual operation function. Roof may deform if hard material such as hammer handle is pinched. (Use hammer handle wrapped with cloth.) iv) Precautions for Disassembly and Reassembly Sun roof consists of many component parts and the following precautions should be observed when performing disassembly and reassembly. Inappropriate handling will spoil its original performance. Check that ignition is “OFF” or battery negative (–) cable is disconnected when operating the sun roof manually. Do not disassemble parts except the parts indicated for disassembly. After performing misalignment correction or emergency manual movement of motor(s) for sunroof, initialize sun roof motors. (Sun Roof Motor Initialization) Check sliding rail surfaces for cleanliness and clean the surfaces if any foreign material is present. Apply grease to sliding parts of sun roof. WARNING During emergency operation of the sun roof motor, the roof may move suddenly and can cause personal injury. (Sun Roof Motor Removal and Installation): Check that ignition is “OFF” or battery negative (-) cable is disconnected when performing emergency operation of the sun roof motor.
RkJQdWJsaXNoZXIy MTIwNTUz