1.2L REVOTRON ENGINE 22 SPECIAL TOOL RH Mounting Bracket - 5424 5890 24 02 37. Safely lift the engine with the help of crane and fix it on overhaul stand. Engine Installation : 1. Engine installation is generally reverse of removal. Make certain all hardware is tightened to appropriate torque specification. 2. Prior to installing the engine, inspect the condition of the rubber on the engine mounts. Replace the engine mounts if the rubber is damaged. 3. Mount the transaxle back onto the engine. Tighten the bolts with specified torque. 4. Install the starter motor and engine wiring harness along with its mounting brackets. 5. With the vehicle raised on the vehicle lift hoist, place the engine underneath the vehicle, aligned with the engine compartment. CAUTION Use care when lowering the vehicle body to the engine and transaxle assembly. Verify all the engine and other components will not make direct contact or vehicle damage will occur. 6. Slowly and carefully raise engine into engine bay. 7. Connect the lifting crane to the engine with a chain / belt. Raise the hoist slightly to apply lifting tension to the engine. 8. Secure the engine in the vehicle by attaching A, B and then C mount in sequence along with brackets. NOTE While tightening of B mount, use 12 mm 3 no’s of sockets on consecutive 3 mounting bolts as shown in fig. 9. With the engine attached to the crane, remove the support stand. 10. Remove the chain / belt after engine mounts are secure. 11. Install the left and right driveshaft assemblies. 12. Connect the gearshift linkage, clutch cable to the engine and transaxle. 13. Connect the engine wiring harness. 14. Connect the cooling system reservoir hoses. Verify the cooling system drain is closed on the radiator. Install the cooling system hoses to the engine, radiator and heater core. 15. To connect the exhaust front pipe tighten the flange near Catcon and connect at rear end. 16. Install the air filter assembly and intake system hoses to the engine.
RkJQdWJsaXNoZXIy MTIwNTUz