BRAKE 32 7. Carefully remove the seal from the caliper pot/cylinder groove, use proper tool. NOTE: Do not use any metal part with sharp edge, ensure no cut mark, scratch in the seal groove, and ensure no damage in the seal groove. Drain the excess oils from the calliper and clean the calliper thoroughly only with isopropyl alcohol 2. ASSEMBLY OF CALIPER 1. Insert seal into groove by rolling the index finger over the seal NOTE: When assembling the seal, ensure in the cylinder groove is free from damage, the bore is smeared with oil. Apply (smear) enough grease to the seal before assembly, inspect the seal for no cut, tear damage and splashes, and after assembly ensure the seal has been seated well in the groove by rolling the index finger over the seal. 2. Insert boot piston into boot groove by rolling the index finger over the boot seating area. NOTE: When assembling the boot piston, ensure in the cylinder boot groove is free from damage, the bore is smeared with oil. Apply (smear) enough grease to the boot piston (inside and boot contact area) before assembly, inspect the boot piston for no cut, tear, damage and splashes, and after assembly ensure the boot piston has been seated well in the boot groove, by rolling the index finger over the boot seating area.
RkJQdWJsaXNoZXIy MTIwNTUz