Using Special Tool, to compress and assemble 7. the valve spring lock halves. Assemble the RRF along with Hydraulic Lash 8. Adjuster from the cylinder head as shown in below figure. Repeat the procedure for exhaust port, noting 9. the locations and components for each valve for proper reassembly. ASSEMBLY OF CYLINDER HEAD IV. Place the cylinder head on the table. 1. Mount the cylinder head gasket over the block. 2. Assemble the cylinder head on the block. 3. Tighten the fasteners as per given sequence. 4. Assemble the lower ITG Bearing Cap with 5. locating dowels. Ensure the NRV (Non return valve) in place inside lower ITG. NOTE To avoid damage to valve tips, do not rotate the camshaft. CAUTION When assembling the camshaft, use care to avoid damaging the bearing surfaces of the cylinder head and the camshaft. NOTE Match the gasket profile to Cylinder block surface as shown in figure.. ENGINE 1.2L BSVI PHASE-2 139
RkJQdWJsaXNoZXIy MTIwNTUz