TIAGO AMT Gasoline DTC Troubleshooting Guide Version: 2.0 Date: 06-06-2016 Author: Sathi/Anupama Page: 356 of 424 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. 122. P080A -07: Kiss point Selftuning Procedure Error Overview: ISO Code P080A -07 Customer Symptom Transmission Fault Lamp ON, Vehicle moving only in 1st or reverse gear. Fault Effects (On Vehicle) Vehicle moving only in 1st or reverse gear. Lamp Status (If Any) Transmission Fault Lamp ON Fault Detection Condition This fault gets detected after Ignition On if TCU detects that the Clutch kiss point self tuning service procedure has not been done or not successfully completed Normal Operating Condition Clutch kiss point self tuning Procedure is successfully completed at End of line or after service part replacements (refer service manual) that require such procedure. Probable Trouble Area Wrong execution conditions /Wiring Harness Connections / TCU Healing Condition Immediately after detection of valid Self tuning procedure completion. Component Details: Clutch kiss point self tuning procedure is Run through a diagnostic or End of line tool, it is required by the TCU to learn the position of clutch kiss point (clutch position at which it starts transmitting torque). Preliminary Checks: 1) Before proceeding with rectification, ensure no other DTC in TCU except from a set of P1844,P080A, and P185B. If th 2) Before re-initiating the procedure check the following conditions: a> Ignition key is ON b> Transmission in neutral c> Healthy battery d> Engine is ON e> Vehicle speed is 0 f> Check correct hydraulic pressure with diagnostic tool (38-51 bar) g> Grid Self tuning procedure is complete (check with diag. tool Selflearned Mask and confirm that variable h> 3) Check for damage or back out of pins at TCU connector. 4) Visibly check for any damage to electro valves/oil leakage/other kit components. 5) Check for loose fitting TCU/EMS/24 pin inter-harness and clutch position/clutch speed sensor connectors 6) Check correct fitment of ground cable connections on vehicle chassis. Trouble Shooting:- Step Checks IF YES IF NO 1. Connect the TCU diagnostic tool and check other than the current one? procedure again. Recheck from step 1 Go to Step 2 2 Initiate the Clutch kiss point selftuning procedure with the diagnostic tool, wait for ~ 1 minutes and ask for routine result. Check for the below responses and steps to follow: -> Goto Step 3 -> Goto Step 4 - -
RkJQdWJsaXNoZXIy MTIwNTUz