SUSPENSION 30 13. ON BENCH REMOVAL AND ASSEMBLY OF WHEEL HUB (GEN1 BEARING) 1. Remove the knuckle Assembly from vehicle.(Refer Front suspension removal Procedure) 2. Remove circlip from knuckle. 3. Remove Hub Assembly using press & Tool Required. 4. Remove inner race of bearing from the hub. ASSEMBLY: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. 2. Tighten the heat shield screw to 1.2 ± 0.05 kgm. 3. Tighten drive shaft nut 30 ± 1.5 kg-m torque and lock by staking. 4. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing and new circlip. SUB ASSEMBLY - KNUCKLE / HUB: Clean all the parts thoroughly and replace damage / worn out parts. 1. Fit bearing in the knuckle 2. Fit circlip. 3. Place the knuckle assembly over the hub. Press the knuckle assembly on the hub.
RkJQdWJsaXNoZXIy MTIwNTUz