DRIVESHAFT (AT) 10 4.Slide the tripot seal smaller end to the corresponding groove on the axle shaft and crimp the small seal retaining clamp (new one) using pincer crimping tool) and maintain max 2.6 mm. ear gap as shown below. (Spider Assembly at approximately middle of the tripot bowl). 5.Slide the new large seal retaining clamp over the housing in the free condition of the boot and housing Insert the swage tool part no: 2779 5890 2001 over the clamp. 6.To avoid any grease leakage issue make sure Clamping of bigger clamp should be in line and on housing portion shown in above image (with Green arrow) C. CV JOINT OUTER DISASSEMBLY: 1.Remove the large seal retaining clamp from the CV joint with a side cutter or a screw-driver with rounded tip and discard. 2.Clean the shaft thoroughly using cleaning solvent and hold the shaft at the middle of the axle shaft in the vice. NOTE Use suitable protective covers to protect the half shaft. 3.Using a suitable drift against the inner part of the CV joint, remove the CV joint from the half shaft.
RkJQdWJsaXNoZXIy MTIwNTUz