TRANSAXLE TA6300 AMT 31 20. Disconnect gear shifter cables. 21. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side/Engine side. 22. Remove Drive shaft from co-driver side. NOTE: Care should be taken not to damage driveshaft oil seal and its boots (do not use hammer). CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 23. Remove Exhaust Front pipe mounting Bracket on silencer support assembly to make accessibility for Hex Flange bolt on gear box. 24. Give support from bottom side of Engine Assembly. 25. Loosen mounting bolts of clutch housing. 26. Remove fuel line supporting bracket from clutch housing. 27. Disconnect high-pressure hose assy. from clutch release lever. 28. Remove C-Bracket mountings from Subframe assembly & Gear box also take out C-mounting bracket. 29. Loosen the B- mountings 30. Remove hex flange bolt on gear box housing.
RkJQdWJsaXNoZXIy MTIwNTUz