TRANSAXLE TA6300 27 17. Remove 2 mtg bolt of intermediate shaft heat shield & take out heat shield. 18. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side. 19. Remove Drive shaft from co-driver side. NOTE: Care should be taken not to damage driveshaft oil seal and its boots (do not use hammer). CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 20. Give support from bottom side of Engine Assembly 21. Remove fuel line supporting bracket from clutch housing. 22. Disconnect high-pressure hose assy. from clutch release lever. 23. Disconnect ‘C’ mount bracket bolt. 24. Loosen and remove B Mount Bracket. With rubber pad. 25. Remove clutch housing mounting bolts. 26. Finally take out Gear box Assembly from vehicle. INSTALLATION: Follow the reverse procedure of Assembly of Transaxle on Vehicle.
RkJQdWJsaXNoZXIy MTIwNTUz