TRANSAXLE TA6300 24 11. Remove ball joint (steering rack) from steering knuckle from both sides. 12. Remove vertical link mountings on suspension rod for both RH & LH sides. 13. Remove starter motor connection & its three mountings & take out starter motor. 14. Disconnect electrical connections of Reverse Light switch. 15. Disconnect power steering pressure line and its mounting over transaxle. 16. Disconnect gear shifter cables. 17. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side/Engine side. 18. Remove Drive shaft from co-driver side. NOTE: Care should be taken not to damage driveshaft oil seal and its boots (do not use hammer). CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 19. Give support from bottom side of Engine Assembly 20. Remove fuel line supporting bracket from clutch housing. 21. Disconnect high-pressure hose assy. from clutch release lever. 22. Disconnect ‘C’ mount bracket bolt.
RkJQdWJsaXNoZXIy MTIwNTUz