14 AIR BAGS SRS 8. PROCEDURE FOR INSTALLATION OF STEERING WHEEL, DRIVER & CO-DRIVER AIR BAG MODULE AND SEAT BELTS. (Ensure that the battery is disconnected while working with the air bag/belt pretensioners). A. STEERING WHEEL 1. Ensure that the vehicle is in Straight Ahead Position (SAP). 2. Insert the steering wheel to the steering column with the clock spring slot aligning with the M clip on the clock spring & rotate the wheel statically to brake the "Center Tag" on the clock spring. Bring the vehicle back to SAP. ENSURE THAT THE PLASTIC BUSH IS PRESENT IN THEMCLIP SLOT ONTHE STEERINGWHEEL BASE PLATE. 3. Remove the steering wheel & re-orient it in the desired SAP orientation. 4. Align the M clip on the clock spring to the slot in the steering wheel manually and tighten the steering wheel on the steering column. B. DRIVER AIR BAG 1. Disconnect battery ground cable and wait for one minute. 2. Connect the air bag inflator and horn function with the clock spring. Install the plastic clamp on floating horn function base plate for inflator connector. 3. Insert the air bag module in steering wheel. Press the module fully and align the mounting tabs with respect to bottom mounting lugs provided on steering wheel. Make sure that gaps at all spokes are maintained uniformly. 4. Tighten the screws located sidewise the steering wheel with specified torque (2.5 kg. m.) 5. Put on the side caps on steering wheel bottom cover. 6. Connect the battery ground cable. C. CO-DRIVER AIR BAG 1. The air bag module has 2 mountings- - air bag cover to the dashboard, - air bag container to the dash board mounting cross member. 2. Insert the complete air bag module into the dashboard off the vehicle and tighten the screws on the bracket provided on dashboard from inside. 3. Assemble the dashboard on the vehicle. 4. Tighten the air bag container with dashboard cross member mounting bracket with bolts with specified torque (2.5 kg. m.) 5. Disconnect battery ground cable and wait for one minute. 6. Put on the air bag connector located sidewise. 7. Fit the glove box assy. 8. Connect the battery ground cable. D. SAFETY BELTS WITH PRETENSIONERS & LOAD LIMITERS 1. Disconnect battery ground cable and wait for one minute. 2. Connect the pretensioner to the wiring harness. 3. Instal l the retractor as per the usual recommended procedure. 4. Make sure that load limiter belts are installed for the occupant provided with air bag. (IF THE VEHICLE IS "DRIVER AIR BAG ONLY" VERSION, THE CO-DRIVER SEAT BELT SHOULD BE OF PRETENSIONER ONLY CATEGORY). E. Observe the SRS warning lamp status for any error codes after the air bag/belt pretensioner connections.
RkJQdWJsaXNoZXIy MTIwNTUz