13 REAR AXLE To remove bearing cup, use Puller slide hammer Pt. No. 2698 5890 3507. Fig. 6 Removal of Unitised bearing. Remove the snap ring from the axle shaft. Clamp axle shaft in a vise. Drill a 6.5 mm hole to the depth of 5 mm in the outside of the retainer ring. Fig. 7 Caution: Dri l l can damage axle shaft i f used negligently. Use chisel and strike sharply to break the ring. Fig. 8 Note: Discard and replace with a new one at time of assembly. Push retainer plate and seal towards flange of axle shafts. Use Bearing Puller for Axle shaft Pt. no. 2698 5890 3521. Install flange plate to the flange of the axle shaft. Install bolts into flange plate. Slide forcing plate over the axle shaft. Install the adapters so that they seat under the cup rib ring. Gradually tighten the bolts until bearing cone is removed. Fig. 9 Caution: Do not heat or cut the bearing cone assembly. Remove seal and retainer plate. Discard Seal. Discard retainer plate, if found distorted. Fig. 7 Fig. 8 Fig. 9 Fig. 6
RkJQdWJsaXNoZXIy MTIwNTUz