55 GEAR BOX G-76 INSTALLATION OF GEAR BOX ASSEMBLY ON VEHICLE Note :Take guidelines from the write up on removal of gear box. Fit clutch housing to gear box front face. Fig. 115 Fit clutch release bearing and release fork. Fig. 116 Lift and mount the gear box at cylinder block face, aligning drive shaft splines with clutch plate hub splines and clearing gear shift lever through opening provided on the cab. Tighten all mounting bolts of clutch housing. Apply grease over supporting pin of extension arm and also inside rubber bush of extension arm support. Slide support over pin. Fit extension arm support (164) on cross member. Tighten nylock nut (167) along with washer (166) such as to maintain a clearance of 10 mm between extension arm stud end and propeller shaft. Fit - Clutch slave cylinder and its piping. - Speedo cable - Reverse indicator switch connector Fig. 117 - Propeller shaft Fix rubber seal in its seat over tunnel cut out and over plate, tighten screws along with washer. Slide rubber bellow over collar of cover plate. Fig. 117 Fig. 116 Fig. 115
RkJQdWJsaXNoZXIy MTIwNTUz