22 BODY 17. REMOVAL/INSTALLATION OF FRONT SEAT (with and without height adjuster Fig. 23) REMOVAL ● Remove the electrical components mounted on the seat frame. ● Remove the front seat mounting screws on the floor and remove the seat. ● Disassemble fuel lid release lever (where fitted) INSTALLATION ● Locate the front seat on the fitment holes. ● Check that the carpet is aligned properly. ● Fit the seat using 6 hex. screws (M8x25), spr. washers (B8), bright washers (8.4) and tighten the screws. ● Check for fuel lid operating cable (if fitted) Note : For vehicles fitted with airbags the front seats mounting arrangement is as shown in fig. 23a Fig. 23. 1. MOUNTING SCREWS FRONT 2. MOUNTING SCREWS REAR 1 2 Fig. 23a Vehicle Front
RkJQdWJsaXNoZXIy MTIwNTUz