21 BODY 1. Rear Bumper skin 2. Tow Hook Cover 3. Foot step plate 4. Assy. side mtg. brkt. LH/RH 5. Adjusting screw 6. Assy. Rear bumper beam 16. REMOVAL/INSTALLATION OF REAR BUMPER (Fig. 22) REMOVAL ● Remove the two screws of each side strip mounting bumper with the rear wheel arch at both sides (at location a, b). ● Remove the mud flap from the side mounting bracket from both sides. ● Remove the electrical connections for fog lamps and number plate lamps. ● Support the bumper and remove the two nuts from each rear mounting bracket from below the bumper (at location c, d). ● Pull out the bumper. INSTALLATION ● Support the bumper and complete the electrical connections for fog lamps and number plate lamps. ● Loosely mount the bumper on side adjusting screws. ● Fit the 2 hex. fl. nuts (M8) and washers (8.4) on each bracket, loosely from below the bumper (at location c, d). ● Adjust the gaps and once they are set tighten the nuts and adjusting screws. ● Fit the mud flap on side bracket at both sides. ● Tighten the two screws of each side strip with the wheel arch at both sides (at location a, b).
RkJQdWJsaXNoZXIy MTIwNTUz