ELECTRICAL 102 8.10.7 HAZARD WARNING SWITCH: FUNCTION: Hazard warning is used in case of breakdown especially during night and the car has to be parked at the side of the road. This switch can also be used when the car is operated in adverse conditions. This switch can be operated without Ignition ON. LOCATION: It is fitted on the Centre finisher. REMOVAL: 1.Remove Center finisher assembly (Refer body section). 2.Disconnect the electrical connection of hazard warning switch. 3.Pry out the Hazard warning switch from centre finisher. INSPECTION: Test the switch with a Multimeter. Clip the probe of the multimeter to switch terminal and body ground and check the continuity. CONDITION SPECIFIED Not Pushed(OFF) No continuity Pushed(ON) Continuity If not as per specified condition, then replace the switch. REFITMENT 1.Locate and fit (snap fit) the switch in the cutout of centre finisher. 2.Connect the electrical connection of the hazard warning switch. 3.Fit the Center finisher assembly (Refer body section).
RkJQdWJsaXNoZXIy MTIwNTUz