ELECTRICAL 42 CONDITION POSSIBLE CAUSE CORRECTION/REFERENCE ITEM 4.FRONT PARKING LAMPS 1. Connector (10 pole) loose. 1. Fix the connector properly. 2. Bulb loose/fused. 2. Fix the bulb properly. Replace bulb if blown. 3. Parking lamp LH/RH fuse (10A) in cockpit fuse and relay box loose/blown. 3. Fix the fuse properly in the base. If blown, check for short in the circuit and then replace the fuse.. Single front parking lamp not working 4. Battery supply not reaching to parking lamp LH/RH fuse input. 4. Check the continuity from battery to the lamps through the master light switch, main W/H and Floor W/H connectors and rectify the discontinuity in the circuit 1. Master light switch connector loose. 1. Fix the connector properly. 2. Master light switch faulty. 2. Replace master light switch. 3. BCM output wire loose. 3. Repair the wiring harness. 4. Parking lamp relay faulty. 4. Replace relay. Both front parking lamps not working 5. Both Head Lamps connectors loose 5. Fix the connectors properly. 5.REAR PARKING LAMPS 1. Parking lamp LH/RH fuse (10A) in cabin fuse box loose/blown. 1. Fix the fuse properly in the base. If blown, check for short circuit in the circuit and then replace the fuse. 2. 6 pole connector from floor W/H to Rear Cluster Lamp loose 2. Fix the connector properly 3. Bulb loose/fused. 3. Fix the bulb properly. Replace bulb if blown. Single rear parking lamp not working 4. Battery supply not reaching to parking lamp LH/RH fuse input. 4. Check the continuity from battery to the lamps through the master light switch, main W/H and Floor W/H connectors and rectify the discontinuity in the circuit. 1. Master light switch connector loose. 1. Fix the connector properly. 2. Master light switch faulty 2. Replace master light switch. 3. BCM o/p open or short circuit. 3. Repair wiring harness. Both rear parking lamps not working 4. Parking lamp relay faulty. 4. Replace relay. 6.REAR TURN SIGNAL LAMPS 1. Connector (6 pole) loose. 1. 1. Fix the connector properly. Rear right/left turn signal lamps not working 2. Bulb loose/fused. 2. Fix the bulb properly. Replace bulb if blown. 1. BCM output open or short circuit. 1. Repair wiring harness. 2. Combi switch faulty. 2. Replace combi-switch. No indicator lamp is working 3. Connector (6 pole) loose.. 3. Fix the connector properly.
RkJQdWJsaXNoZXIy MTIwNTUz