ELECTRICAL 41 ELECTRICAL 8.4.3 DIAGNOSTIC INFORMATION AND PROCEDURES FOR ALL LAMPS CONDITION POSSIBLE CAUSE CORRECTION/REFERENCE ITEM 1.HEAD LAMP 1. Head Lamp connector (10 pole) loose. 1.Fix the connector properly. Single head lamp (RH or LH) not working 2. Bulb fused. 2.Replace bulb. 1. High/Low beam filament in the bulb blown. 1. Replace bulb. Single head lamp (RH or LH) not working in high/low beam properly 2. High/Low beam terminal (Pink/Blue wire) has come out off the connector. 2. Insert the terminal into the connector properly. 1. Head lamp high/low beam fuse (10A) in engine relay and fuse box loose/blown. 1. Fix the fuse in the base properly. If blown, check for short in the circuit and then replace the fuse. 2. Connectors at master light switch loose/10 pole connector from main W/H to cockpit W/H loose 2. Fix the connectors properly. 3. HighILow beam switch in master light switch faulty. 3. Replace master light switch. 4. BCM connector loose. 4. Fix the connector properly. Both lamps not working in high/low beam 5. Relay faulty. 5. Replace relay. 1. Connectors at combi switch loose. 1.Fix the connectors properly. 2. Flash switch faulty. 2.Replace combi switch. 3. High beam bulb blown. 3.Replace bulb. High beam does not come on when flash switch is activated 4. High beam relay faulty. 4.Replace relay. 2.FRONT TURN SIGNAL LAMPS 1. Connector(10 pole) at the lamp loose 1. Fix the connector properly. 2. Bulb loose/fused. 2. Fix the bulb properly. Replace bulb if blown. 3. BCM output open. 3. Repair the wiring harness. Front right/left signal lamps not working 4. Wiring harness short circuited 4. Repair the Wiring harness. 3.REVERSE LAMPS 1. Bulb loose/fused. 1. Fix the bulb properly. Replace bulb if blown. Single reverse lamp not working 2. 6 pole connector from main W/H to Rear Cluster Lamp loose 2.. Fix the connector properly 1. Reverse lamp fuse (10A) in cockpit fuse and relay box loose/blown. 1. Fix the fuse properly in the base. If blown, check for short in the circuit and then replace the fuse. 2. Reverse lamp switch faulty. 2. Replace reverse lamp switch. Both reverse lamps not working 3. 6 pole connector from main W/H to Rear Cluster Lamp loose 3. Fix the connector properly
RkJQdWJsaXNoZXIy MTIwNTUz