ELECTRICAL 37 ELECTRICAL 9.Slide commutator end shield onto armature shaft. 10. With the help of a feeler gauge, set armature end play to 0.05 to 0.4 mm using only one shim. (Shims of thicknesses 1.0, 1.2 and 1.4 mm are available). Insert lock washer. Lightly grease holding disc and shim with silicon grease. Mount seal and closing cap and lightly tighten the screws by hand. 11. Slide armature with brush plate and commutator end shield carefully into stator frame. Fit rubber seal on terminal 45 (brush plate) into groove on stator frame. Position the stator frame on the drive end bearing housing. Turn the pinion until the armature latches into the gear wheels. The groove on the stator frame fits on to the sealing rubber of the bearing pedestal. 12. Position the through bolts and tighten to 0.45 Kgm to 0.60 Kgm. Tighten the fastening screws of closure cap to 0.14 to 0.20 Kgm. 13. Hook the solenoid armature into the fork lever. Insert solenoid armature return spring and screw down the solenoid housing to torque (0.45 to 0.63 Kgm). 14. Reconnect the supply terminal and tighten nut with washer on the solenoid.
RkJQdWJsaXNoZXIy MTIwNTUz