ELECTRICAL 36 ASSEMBLY: 1.Lightly oil pinion bearing surface. Lightly grease spiral splines of armature shaft. 2.Slide overrunning clutch with fork lever and bearing pedestal on to drive shaft. Slide stop ring onto shaft. 3.Using pliers slightly open up new retainer and insert into armature ring groove. 4.Slide mounting sleeve 03-KDAL 5028 onto armature shaft (turned side of sleeve pointing to retainer) and caulk retainer into stop ring using 03-KDAL 5487 and a mallet. Alternatively, press the retainer into the stop ring with tool 03-KDAL 5028 using an Arbor Press supporting the pinion on supporting plate H-S/KDEP 189 as shown in figure. 5.Align the marks made during dis-assembly and insert the epicycloidal gear with pinion, overrunning clutch, fork lever and bearing pedestal into the drive end bearing housing. Insert rubber seal. 6.Align the marks and position the cover plate on the ring gear. 7.Position tool H-S/KDEP 188 with brush plate on the armature shaft at the commutator end and slide the brush plate over the commutator, making sure that the brush holders are properly seated at anchor point. Remove the tool. 8.Lightly oil gasket (felt ring) with oil and insert on commutator end.
RkJQdWJsaXNoZXIy MTIwNTUz