Rear Axle 28 Remove Bearing from Bearing Holder Put the bearing holder on the bottom locator (as shown), install bearing removal adaptor & press down the bearing to remove from the bearing holder. Note: Its 700 Kgf to 1500Kgf Force Required to Fit & to Remove Bearing from Bearing Holder. Note: It's recommended not to use bearing once removed from axle shaft if grease is spilling out from bearing. 5.2 ASSEMBLY OF AXLE SHAFT ASSEMBLY Press Bearing Into Bearing Holder Put the bearing housing on base plate install the bearing & bearing pressing dolly, Press down the bearing into bearing housing. Install Brake Assembly & Press Bearing Housing on Axle Shaft Put the brake assembly & install the bearing housing, Pull up the brake assembly bolt through bearing housing flange hole & put the nut on it & tighten it by hand. Remove the legs of the bearing puller by removing the nuts & bolts, remove the handle as well & Install the bearing puller (without legs & handle) on the axle shaft, now press bearing down on axle shaft by pressing with help of Bearing puller (without legs & handle). Remove the nut from the brake assembly bolts. Install & Torque Locknut Press Tone Ring Put the thrust washer & lock washer while aligning the same in the groove on axle shaft, Install & tighten locknut manually. Now put the locknut torturing adaptor & socket as done while removal & tighten the same with torque wrench set at 300 N-M Torque. Fig. 5.08
RkJQdWJsaXNoZXIy MTIwNTUz