Rear Axle 24 Assemble the adaptor plate into the bottom side gear. Apply small amount of grease to centering hole of adaptor plate. Assemble threaded adaptor in top side gear Use small screw driver to position in slot of threaded adaptor. Torque forcing screw until it becomes slightly tight. Remove both pinion mate spherical washers. Use shim stock of 0.76mm (0.030”) thick or equivalent to push out spherical washer. Relieve Tension of the Belleville springs by loosening the forcing screw. Insert small OD end of turning bar into cross pin hole of case. Pull on bar and case will rotate until the pinion mate gears can be removed from opening. It might be necessary to adjust the forcing screw slightly to allow the case to rotate. Hold top clutch pack with one hand & remove tools. It might be necessary to hold threaded adaptor with screw driver as shown in. Remove top side gear and clutch pack. Keep the stack of plates and discs intact in exactly the same position while they are being removed. Remove the case from the axle shaft. Turn case with the flange or ring gear side up and allow the step plate, side gear and clutch pack to be removed from the case. Remove the retainer clips from both clutch packs to allow separation of plates and discs. Keep the stack of plates and discs exact as they were removed.
RkJQdWJsaXNoZXIy MTIwNTUz