FRONT SUSPENSION 18 Ensure no fouling with other components filling fitment of shims. 2. Fit the upper wishbone ball joint to knuckle and tighten it to the specified torque and insert the split pin. 3. Apply the specified torque to the upper link mounting bolt after ensuring that the distance between upper surface of shock absorber tower and upper link (the point in the link where the circular section starts) at front and rear is as follows. Distance at front: 9mm Distance at rear: 50mm NOTE Upper wishbone torque to be given in the above specified condition.(Refer tightening torque table) Before assembly check condition of ball joint, Check excessive play in the ball joint, if excessive wear is found replace the same with new one. Ball Joint Axial Play 0.1 mm max. Ball Joint Radial Play 0.2 mm max. NOTE Always follow standard procedure for checking the ball joint play.
RkJQdWJsaXNoZXIy MTIwNTUz