FRONT SUSPENSION 16 C. LOWER WISHBONE REMOVAL 1. Remove the lower mounting of Strut assembly from the lower wishbone. (For procedure refer front Strut assembly removal procedure in this section). 2. Remove the split pin and thin Castle nut. 3. Support the lower wishbone and knuckle separately. 4. Place the puller (1) (Part No. 287058904601) in the between ball joint and front axle. 5. Tighten the hex screw (2) inside the puller (1) (Part No. 287058904601) in clockwise direction to push the ball joint upwards and take out the ball joint. 6. Slightly move the knuckle assembly to separate the ball joint from the knuckle. 7. Loosen and remove the eccentric pin assembly (2 Nos.) of lower wishbone which are attached to the frame and take out the lower wishbone assembly. FITMENT For fitment follow the reverse procedure of removal. If required add the shims as given in the figure below to fill the gap. Ensure no fouling with other components during fitment of shims. NOTE Lower wishbone eccentric pin to be tightened to specify torque after wheel alignment is done. Before assembly check the condition of ball joint. Check for excessive play in the ball joint, if needed replace the same with new one. Make sure that all the mountings are tightened to the specified torque.
RkJQdWJsaXNoZXIy MTIwNTUz