ENGINE 137 4. Lift the in-tank pump carefully out from the tank. FITMENT Follow the reverse order of removal for fitment. NOTE Care should be taken while removing and fitment so as not to cause any damage to the float arm. INSPECTION Use multimeter to confirm that the resistance of the fuel level sensor changes with the level of float position. Measure the resistance in pins B and C. refer next page for values at different heights of the float. E FUEL LEVEL SENSOR REMOVAL 1. Remove the tank unit. 2. Disconnect the connector. 3. Remove the fuel level sensor by releasing the snaps. FITMENT Follow the reverse order of removal for fitment. 3.1.7.4. FUEL TANK PURGING PROCEDURE WARNING The purging may not remove all fuel vapours. Therefore any repair on fuel tank using external heat or flame may result in explosion causing personal injury or damage. 1. Remove fuel tank from the vehicle. Refer procedure as mentioned for fuel tank removal. 2. Remove all fuel lines from fuel tank. 3. Remove fuel pump and fuel level gauge from fuel tank. 4. Shift the tank to flushing area. 5. Fill tank with warm water or normal tap water and agitate rigorously and drain the water through drain plug. Repeat this procedure until inside of the tank is clean. 6. Replace the tank if it is rusty from inside. 7. Completely flush out remaining water after washing. CAUTION Do not allow water to remain inside fuel tank after washing. This will cause corrosion inside fuel tank. Use shop cotton cloth for tank cleaning. Do not use cotton waste
RkJQdWJsaXNoZXIy MTIwNTUz